dsh-chonky-fps
Chonky frame-rate mode for DeepSeek Harness.
Four tiers, locked on selection: Normal dive 60Hz, Soft & squishy 90Hz, Bubble dash 120Hz, Full-speed tail whip 144Hz.
This frame-rate mode is for DSH only.
What it does
- Adds a Chonky frame-rate mode page to DSH Web Settings with the four tiers.
- Provides a native panel in the dsh-go phone app (plugins page, all features, session detail, composer "+"); the phone and the Web page share one stored value.
- Locks the chosen tier: the preview trail advances at that tier's frame interval and re-asserts on tab switch; the tier is also published as
data-frame-modeand the--dsh-frame-hzCSS variable so the page can drive one refresh rhythm. - Measures the screen refresh rate and reports lock state: "Locked at ≥120Hz (measured 121Hz)" when reachable, "Not locked: the screen tops out near 60Hz" when not.
What it does not do
It cannot raise your real frame rate. The plugin cannot change your hardware or browser ceiling. On a 60Hz screen, picking the 144Hz tier does not make the screen run at 144 frames per second: the page reports it honestly as "Not locked: the screen tops out near 60Hz, so 144Hz is unreachable" instead of pretending it worked. That message is the correct behaviour, not a fault — expecting 144 real frames on a 60Hz panel is the misconception.
It does not raise frame rates in games or video either — it only affects DSH's own UI.
Frame rate is unrelated to tokens: raising or lowering it neither adds nor saves tokens, and the plugin never calls a model.
Install
dsh plugin --profile web add dsh-chonky-fps
Or install it from the plugin market.
Restart the engine after installing.
dsh plugin addwrites the plugin row to your profile but does not reload it. Until you restart, the engine can fail on startup withpatch: entry "<id>" not found, and the dsh-go panel reports "plugin disabled or not found". Restart the engine (App → Engine → Restart, or restartdsh web), then refresh the Web page; on the phone enable it under Settings → Plugins.
If the tiers still do not appear after a restart, restart once more: the first start after an install is the one that picks the new plugin up.
Tiers
| Tier | Rate | id |
|---|---|---|
| Normal dive | 60Hz | dsh-chonky-fps-60 |
| Soft & squishy | 90Hz | dsh-chonky-fps-90 |
| Bubble dash | 120Hz | dsh-chonky-fps-120 |
| Full-speed tail whip | 144Hz | dsh-chonky-fps-144 |
State file: ~/.dsh/chonky-fps.json. Delete it to fall back to the 60Hz default.
License
MIT
No comments yet. Be the first to write one.