commandcode-dash

English | 中文

Command Code credits, usage windows, and model catalog — inside the DeepSeek Harness settings panel.

Unofficial community plugin. Not affiliated with DeepSeek or Command Code.

A DeepSeek Harness (DSH) web plugin that adds a Command Code section to the settings panel:

• Plan, credit balance, the 5-hour and weekly usage windows with live reset countdowns, and the current billing period's totals.
• The configured model catalog, diffed against the live provider/v1/models catalog — with a one-click sync.

Features

Credits	Monthly, purchased, and free credit balances from the live billing API.
Usage windows	5-hour and weekly windows as used / cap with progress bars and resets in … countdowns that tick without refetching.
Billing period	Requests, success rate, credits consumed, and token totals.
Model catalog	Every configured model with its context window, searchable.
Catalog sync	Diffs the live catalog against your config, then applies additions, context-window fills, and removals — each on your say-so.
Setup card	When no key is configured, the section becomes a form that stores one write-only.
Load once	The section loads on your first visit and renders that same answer on later visits; the ⟳ buttons reload it on demand.

Preview

Requirements

• A DSH install with the web profile available.
• A Command Code plan with Provider API access — every plan except Go.
• Node 20+ on the host (the plugin uses AbortSignal.any).

Installation

From npm

dsh plugin --profile web add commandcode-dash

Restart dsh web.

Configuration

The API key

The key is read from exactly one place: the harness credential store, under the reference COMMANDCODE_API_KEY. The section's own setup card writes it there, or you can add it by hand:

# ${DSH_HOME:-$HOME/.dsh}/.credentials.yaml
refs:
  COMMANDCODE_API_KEY: user_…

It is resolved host-side once per request, so saving one takes effect on the next refresh — no restart.

The model provider

Saving the key is the whole setup. Once it checks out, the section adds the llm-pi-ai provider routes itself, using the catalog fetched from provider/v1/models:

Route	Protocol	Models
commandcode	openai-completions	everything except Claude
commandcode-anthropic	anthropic-messages	Claude, which Command Code only serves over /messages

Disclaimer

This is an unofficial, community-built plugin. It is not affiliated with, endorsed by, or sponsored by DeepSeek or Command Code, and it is not part of either product.

It talks to Command Code's Provider API using your own API key, over the same endpoints the Command Code CLI uses for its own usage screen. Nothing is sent anywhere else.